Utilizing entirely passive filtration technology,
WaveGuide ™ greatly reduces the common mode
noise that travels along power cords, interconnects and speaker cables. Common mode noise can
cause power supplies to modulate in all types of
audio and video electronics. This type of noise,
in conjunction with the modulation it produces,
contributes to undesirable increase of grain, glare
and loss of dimensionality.

The WaveGuide ™ is designed to fit around power, interconnect or loudspeaker cables. Precision machined from a solid block of Delrin®, WaveGuide ™ has excellent dielectric properties, vibrational inertness and is relatively soft (to avoid the possibility of cosmetic damage to adjacent equip-ment.)

To install, simply open the WaveGuide ™ using
an Allen wrench (supplied), lay your cable in the
bottom milled channel, then place the top half
over the cable and tighten the attachment screws.
Since the WaveGuide ™ is completely passive and
requires nothing more than your cable pass
through it, is easy to move up and down the cable
to "tune" the entire system.

The sonic improvement afforded by the WaveGuide ™ is nothing less than astonishing. Bass is tighter, deeper and more articulate. Hollow-bodied acoustical instruments take on a fuller and much more life-like presentation. The midrange is rendered much more naturally without even a hint of glare or edge. Vocals take on a realistic presence within an accurately portrayed three-dimensional acoustical

- Recommended for use on power, audio, video and
digital cables.

- Passive inductive circuit improves low-frequency
noise attenuation.

- Fits around any cable up to 5/8" (1.6 cm.)

- Complete installation in less than five minutes.

Specification